| Brand | Ultimate Body Press |
| Color | Black |
| Maximum Weight Recommendation | 300 Pounds |
| Mounting Type | Ceiling Mount |
| Material | Alloy Steel |
£28.26
Free Shipping on Orders Over a Certain Amount
| Brand | Ultimate Body Press |
| Color | Black |
| Maximum Weight Recommendation | 300 Pounds |
| Mounting Type | Ceiling Mount |
| Material | Alloy Steel |
You must be logged in to post a review.
© 2026 All rights reserved. tesoltrainingscotland.co.uk
Ms. Kaela Beier I –
It was very easy to install. Once it was installed it was mounted solidly without any sway. Great quality product. Multiple angles to do pull ups on.
Miss Earline Hahn Jr. –
Excellent product! I’m about 225lb and was able to do about 8 pull-up with no problems and it’s a solid product!However, I strongly encourage measuring the distance between ceiling joists. While 16 inches & 24 inches are considered standard; I unfortunately discovered that mines were not 16 but rather 18 or I just happen to pick the spot that wasn’t standard size.Small problem that was resolved with a 2x6x30 inches board anchored to the joists and the pull up bar anchored to the board. I added additional screws in the board for added comfort.Total additional cost was approximately $20.00 because I had to buy the entire 2x6x12 board…so the additional pieces will become shelves.
Jaylon Orn –
The best place in my exercise room for a pull up bar was the ceiling, and this bar is absolutely perfect.The room has a 7 ft ceiling and I mounted it on two ceiling joists that were 24 inches apart. The installation template that came with the bar to show where to drill the holes worked perfect. My joists were about 1.5 inches wide and I mounted it 8 inches from the start of an angled wall (would not have worked on the angle wall, had to be the ceiling).I’m 5 ft 10 and was a little worried about my head hitting the ceiling when I did a pull up, but the distance from the ceiling to the bar is perfect (its exactly 16.25 inches from the ceiling to the lowest point on the center of the bar). I thought about mounting a 2X6 board between the two risers and the ceiling like others have done, but it just wasn’t needed in my setup (and with only a 7 foot ceiling I didn’t want the bar any closer to the floor than it had to be)I was also a bit worried about how sturdy it would be but it turned out solid. I’m 180 pounds and there’s no movement or sway at all when I use it. Its anchored into the ceiling tight. I also hung suspension bands from the bar and did a workout just to test the weight limit, and it worked fine … no movement in the bar at all.The multiple different hand positions / grips make this a lot better than the straight pull up bar I grew up with (and the grips on this are very well padded).Installation took a little over an hour because I carefully measured and used a stud finder to ensure I drilled into the middle of the joists. The following tips that others put in their reviews helped a ton:> When you drill the pilot hole with the 5/16 drill bit, make sure the depth of the hole is 3 inches (measuredAFTER the bit is installed in the drill)> Don’t tighten the allen wrench bolts all the way until the very last step (it’s easy to finish that last step and attach the bar to the risers, after the risers are mounted to the ceiling)> Use a 17mm (or 11/16) ratchet to attach the risers to the ceiling (I used a 17mm drill attachment)It turned out perfect and I’d definitely recommend this to anyone looking for a ceiling pull up bar.